Quadra-Fire Direct Room CASTILE-GAS-CWL Manuel du propriétaire télécharger pdf (Page 32)

Page 32

September 1, 2008

Quadra-Fire · Castile Gas Stove · 7023-111E

Handle glass assembly with care.

CAUTION

• Inspect the gasket to ensure it is undamaged.

• Inspect the glass for cracks, chips or

scratches.

• Do NOT strike, slam or scratch glass.

• Do NOT operate appliance with glass door

removed, cracked, broken or scratched.

• Replace glass assembly as a complete

assembly.

I. Glass Door Assembly

Figure 8.15 Turn the appliance OFF and let it cool down before

replacing the inner glass door assembly.

Remove the glass door assembly by opening latches at the

bottom front of the appliance, on both the left and right sides.

Lift out and away from the appliance.

Replace with a new glass door assembly.

NOTE: The glass, gasketing, and frame must be replaced

as a complete unit as supplied by the manufacturer.

Do NOT use substitute material.

J. Blower Installation

TOOLS REQUIRED: #2 Phillips head bit; hand drill; 11/16

in. wrench; and a 5/16 in. wrench.

Snap disc

through bracket

5/16" nut

FROM THE KIT YOU WILL NEED: Blower motor; wire

harness; rheostat; rheostat nut; knob; screws; and 1 zip-tie.

FROM THE STOVE COMPONENT BAG YOU WILL

NEED: snap disc bracket and 5/16 in. nut.

Figure 8.16 Turn off gas supply (if gas is connected), and

remove the rear shield. Remove the blower from packaging.

Place the blower under the appliance. Attach the blower

from the front with four screws to the blower bracket.

Figure 8.17 Install the snap disc in the bracket. Attach the

bracket to the ﬁrebox with a 5/16 in. wrench.

Figure 8.18 Connect the electrical connector to the snap

disc.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 55 56

Pas de commentaire

Quadra-Fire Direct Room CASTILE-GAS-CWL Manuel du propriétaire Page 32