Quadra-Fire EDGE 60 Manuel du propriétaire télécharger pdf (Page 17)

December 6, 2011

7051-158B

Page 17

EDGE 60 Pellet Fireplace

4. Cleaning Heat Exchanger, Drop Tube & Exhaust

• Frequency: Monthly or every 1 ton of fuel (aprx. 50

bags).

• By: Homeowner

NOTE:

There are heavy duty vacuum cleaners speciﬁ cally

designed for solid fuel appliance cleaning.

WARNING! Hopper Fire Risk!

For trouble free use of your pellet appliance you must per-

form cleaning as called for in these instructions. Not doing

so will result in:

• Poor operating performance

• Smoke spillage into the home

• Overheating of components

Not properly cleaning your appliance on a regular basis will

void your warranty.

Tools Needed: A Shop Vac and generic micro cleaning

kit; ﬂ at head and Phillips screwdriver; 11/32 Nut-driver or

wrench.

* Can be purchased at your local hardware store.

1. It is necessary to remove the bafﬂ e to gain access to the

heat exchanger. Follow instructions for bafﬂ e removal

on page 50.

2. Vacuum the ash from the heat exchanger with an

upholstery brush to remove the majority of the ash. Be

sure to vacuum the back of the bafﬂ e also. Inspect the

drop tube and remove any residue build-up in the drop

tube. Figure 17.1.

se the crevice tool to ﬁ nish cleaning the heat exchanger

ﬁ ns. It is critical that the 2 exhaust exits at the back of the

ﬁ rebox ﬂ oor (left and right) be thoroughly cleaned. Figure

17.4. There are several ways this can done.

a. Use the crevice tool.

b. Attach a hose 1/2 inch (12.7mm) in diameter and

approximately 2 feet (607mm) in length to your vacuum

hose.

c. Use a bottle brush and push the ash down to the

bottom. Remove the combustion (exhaust) blower

and then vacuum out the ash.

Figures 18.1 and 18.2

on page 18.

2 exhaust exits (left and right side) must

be thoroughly cleaned. Each exit is

approximately 4 inches wide, 1 inch

across and 3 inches deep.

Assemble the crevice tool from the micro cleaning kit

to attach to a Shop Vac. Figure 17.3.

Figure 17.4

Figure 17.1 - Example of a dirty heat exchanger

Figure 17.2

Figure 17.3

Shop Vac* Example

Micro Cleaning Kit*

Example

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Quadra-Fire EDGE 60 Manuel du propriétaire Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Quadra-Fire EDGE 60