Quadra-Fire EDGE 60 Manuel du propriétaire Page 23
- Page / 58
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
R
December 6, 2011
7051-158B
Page 23
EDGE 60 Pellet Fireplace
5
Getting Started
Installer’s Guide
A
.
Design, Installation & Location Considerations
WARNING! Risk of Fire Damaged parts could impair safe
operation. Do NOT install damaged, incomplete or substitute
components.
1. Appliance Location
NOTICE: Contact local building or fire officials about
restrictions and installation inspection requirements in your
area.
• Installation MUST comply with local, regional, state and
national codes and regulations.
• Consult insurance carrier, local building inspector, fi re
offi cials or authorities having jurisdiction over restrictions,
installation inspection and permits.
It is a good idea to plan your installation on paper, using
exact measurements for clearances and fl oor protection,
before actually beginning the installation. Location of the
appliance and chimney will affect performance.
Consideration must be given to:
• Safety, convenience, traffi c fl ow
• Placement of the chimney and chimney connector and
to minimize the use of chimney offsets.
• Place the appliance where there will be a clear passage
for a Listed chimney through the ceiling and roof (verti-
cal) or through exterior wall (horizontal).
• Installing the required outside air kit will affect the loca-
tion of the vent termination.
When locating vent and venting termination, the ideal loca-
CAUTION!
If burning shelled fi eld corn, you must use ap-
proved venting specifi cally designed for corn to prevent
corrosion or degradation. Follow the instructions from the
venting manufacturer.
Marginal Location:
• Below peak
Location NOT recommended:
• Not the highest point of the roof
• Wind loading possible
Multi-level Roofs
Windward
Leeward
Recommended:
Outside Air Intake
on windward side
NOT recommended:
Outside Air Intake
on leeward side
Recommended Location:
• Above peak
Recommended:
• Insulated exterior chase
in cooler climates
Recommended Location:
• Above peak
• Inside heated space
Location NOT recommended:
• Too close to tree
• Below adjacent structure
• Lower roof line
• Avoid outside wall
Marginal Location:
• Wind loading possible
Figure 22.1
tion is to vent above roof line when possible. This mini-
mizes the affects of wind loading.
Since pellet exhaust can contain ash, soot or sparks, you
must consider the location of:
• Windows
• Air Intakes
• Air Conditioner
• Overhang, soffi ts, porch roofs, adjacent walls
• Landscaping, vegetation
• Horizontal or vertical vent termination
2. Floor Support
The supporting fl oor under the appliance must be able to
handle the weight of the fi replace, fuel load and the weight
of the chimney.
Ensure that your fl oor will suport these weights prior to in-
stallation. Add suffi cient additional support to meet this
weight requirment prior to installation. The weight of the
fi replace is 450 lbs and with a full hopper of fuel weighing
120 lbs, the total for the fi replace and fuel is 570 lbs.
- EDGE™ 60 1
- ATTENTION: 2
- User’s Guide 3
- TABLE OF CONTENTS 3
- Listing and Code Approvals 6
- by sifting 8
- (such as soybean oil) 8
- F. Before Your First Fire 9
- E. Power Switch 9
- EDGE 60 Pellet Fireplace 10
- H. Starting Your First Fire 10
- I. Ignition Cycles 10
- (Feed Rate) Adjustment 12
- L. Clear Space 13
- A. Proper Shutdown Procedure 14
- Troubleshooting for Homeowner 21
- B. Wall Control Error Codes 22
- Error Message 22
- Installer’s Guide 23
- C. Tools And Supplies Needed 24
- Crush Hazard! 25
- WARNING 25
- A. Recommended Locations 26
- B. Hearth Extension 26
- D. Frame the Fireplace 27
- Envelope 27
- E. Construct the Chase 28
- F. Finishing Material 29
- Tuscan and Natural Fronts 30
- Opening Clearances 31
- (1:1 rise to run ratio) 32
- I. Non-Combustible Materials 33
- J. Combustible Materials 33
- Installation of Fireplace 34
- B. Avoiding Smoke and Odors 39
- Negative pressure can 40
- C. Negative Pressure 40
- D. Draft 40
- F. Equivalent Feet of Pipe 41
- G. Pipe Selection Chart 42
- Left Rear Corner 43
- Right Rear Corner 43
- Rear of Fireplace 43
- Install Outside Air Kit 44
- Non-combustible 46
- Hearth Extension 46
- 0 in. (0mm) to Standoff 46
- Mobile Home Installation 47
- Appliance Set-Up 48
- Hinge on Fireplace 49
- Hinge on Front 49
- Start with Bottom Hinge 49
- Alignment and then Top 49
- Hinges Aligned 49
- Remove 4 screws 50
- Glass with Gasket 50
- Metal Bracket 50
- Page 52 52
- 7051-158B 52
- December 6, 2011 52
- 4-7/8 in 53
- Reference Materials 53
- B. Component Functions 54
- Control Board Schematic 55
- Slide Rails 56
Produits connexes et manuels pour Poêles Quadra-Fire EDGE 60
(52 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.089 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels