Quadra-Fire EDGE 60 Manuel du propriétaire télécharger pdf (Page 41)

December 6, 2011

7051-158B

Page 41

EDGE 60 Pellet Fireplace

E. Chimney and Exhaust Connection

1. Chimney & Connector: Use 3 or 4 inch (76-102mm)

diameter type "L" or "PL" venting system. It can be vented

vertically or horizontally.

2. Mobile Home: Approved for all Listed pellet vent. As

with all installations a Quadra-Fire Outside Air Kit must

be used with manufactured home installations.

3. INSTALL VENT AT CLEARANCES SPECIFIED BY THE

VENT MANUFACTURER.

4. Exhaust Venting System: Secure to the appliance with

at least 2 screws 180 degrees apart. Also secure all

connector pipe joints with at least 3 screws through each

joint.

NOTE: All pipe must be welded seam pipe whenever

possible. Seal pipe joints with high temperature silicone

(500°F [260°C] minimum rated only).

NOTE: If burning shelled ﬁ eld corn, you must use

approved venting speciﬁ cally designed for corn. Follow

the instructions from the venting manufacturer.

• Only LISTED venting components may be used.

• NO OTHER vent components may be used.

• Substitute or damaged vent components may impair

safe operation.

WARNING! RISK OF FIRE!

WARNING! RISK OF INJURY OR PROPERTY

DAMAGE!

• Improper installation, adjustment, alteration, service or

maintenance can cause injury or property damage.

• Refer to the owner’s information manual provided with this

appliance.

• For assistance or additional information consult a qualiﬁ ed

installer, service agency or your dealer.

The table below can help you calculate the equivalent feet

of pipe which is a method used to determine pellet vent size.

Figure 40.1.

F. Equivalent Feet of Pipe

Figure 40.1

2 ft.

3 ft.

2 ft.

Example of 3 Elbow-Rear Vent Termination Calculation

Pellet Venting

Component

# of

Elbows

Feet of

Pipe

Multiplied

Equivalent

Feet

Components

Equivalent Feet

Elbow or Tee

3X5 15

Elbow

X 3

Horizontal Pipe

7X 1 7

Vertical Pipe

2X 0.5 1

Total Equivalent Feet 23

Note: This is a generic example and is not

intended to represent any speciﬁ c fuel type.

Vent surfaces get HOT, can cause burns

if touched. Non-combustible shielding or

guards may be required.

WARNING

CAUTION!

• DO NOT CONNECT THIS UNIT TO A CHIMNEY

FLUE SERVING ANOTHER APPLIANCE.

• DO NOT INSTALL A FLUE DAMPER IN THE EX-

HAUST VENTING SYSTEM OF THIS UNIT.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Quadra-Fire EDGE 60 Manuel du propriétaire Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Quadra-Fire EDGE 60