Quadra-Fire EDGE 60 Manuel du propriétaire télécharger pdf (Page 15)

December 6, 2011

7051-158B

Page 15

EDGE 60 Pellet Fireplace

D. Accessing Components for Maintenance

Pellets Back-Up

in Feed Tube

Firepot Overfills

Ash Build-Up in Firebox

Figure 15.1

If the ash build-up exceeds the half way point in the ﬁ repot

before it automatically cleans, then the ﬁ repot is not being

cleaned often enough.

Another symptom is if clinkers are adhering to the sides of

the ﬁ repot.

Double check the wall control to ensure the proper setting

has been selected for the fuel you are burning. If that is cor-

rect, change the setting to “Utility Pellet”.

NOTE: You will need to empty the ash pan more fre-

quently if using the “Utility Pellet” setting.

C. High Ash Fuel Content Maintenance

• Frequency: When the ash build-up exceeds the half

way point in the ﬁ repot

• By: Homeowner

WARNING! Risk of Fire and Smoke!

• High ash fuels or lack of maintenance can cause ﬁ repot to

overﬁ ll. Follow proper shutdown procedure if ash buildup

exceeds half way point in ﬁ repot.

• Failure to do so could result in smoking, sooting and pos-

sible hopper ﬁ res.

Figure 15.2

One bolt located on each side of fireplace

Pull fireplace toward you until

fully extended

Slide Rails

Figure 15.3

Follow the proper shutdown procedure found on page 14.

2. Remove the Front. Lay it on a soft surface to prevent

scratching.

3. Remove both bolts located on each lower side of the ﬁ re-

place with a Phillips head screwdriver or socket wrench

and set aside. Figure 15.2.

4. Pull the ﬁ replace towards you until fully extended. Figure

15.3.

5. Components are now exposed for service.

6. Slide the ﬁ replace back into the outer can. Re-attach the

bolts ensuring that the attachment brackets are securely

fastened. This will prevent the ﬁ replace from unexpect-

edly sliding out on the rail system. Figures 15.4 and

15.5.

7. Double check the bolts and brackets are correctly

positioned to ensure the exhaust gaskets are prop-

erly sealed to prevent combustion leakage.

Attachment brackets shown in open position.

Fireplace is not secure and can roll forward

on the rails. Also the exhaust gaskets are

not sealed properly and combustion leakage

will occur.

Brackets separated

Figure 15.4

Attachment brackets are tightly fastened to one another so

fireplace is secure and will not roll forward on the rails. It also

ensures the exhaust gaskets are sealed properly to prevent

combustion leakage.

Figure 15.5

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Commentaires sur ces manuels

Pas de commentaire

Quadra-Fire EDGE 60 Manuel du propriétaire Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Quadra-Fire EDGE 60